Mustang Tail Light Tint Installation Instructions

We decided to put together a little how to on the installation of our vinyl tail light tints. While the process is very simple, the instructions below should help anyone with addtional questions about the install process. Here it goes...


Materials Needed
Spray bottle with warm water and three drops of liquid soap.
Squeege for installation (included with tints)
Paper Towels

Step One:
Thoroughly clean the surface of the lens in which you are applying the tint to.

Step Two:
Peel off backing from tint as shown below. (avoid from touching any foreign surfaces)


Step Three:
Generously spray soapy solution onto the adhesive side of the tint film and the lens you are working on.


Step Four:
Align tint and apply by using squeege to smooth the film over the lens you are working on. Start at the center of the lens and move outwards with the squeege.


Step Five:
Repeat the above mentioned steps for the remainder of the lenses you are applying the tint film to. If the tint becomes misaligned, you may peel it up and re-apply it.

Things To Remember:
Small air bubbles, minor scratches, and/or haziness will disappear after tint settles and warms up.
You can maintain the appearance of the tint after installation by waxing every so often.
Tints are for show and off-road use only. Check local laws before installation.
The installation process is the same for all vinyl tint products we offer. If you have further questions about the tint installation process, please feel free to contact us:sales@stangmods.com

As always, have fun in your Stang and be safe!